You can obtain the latest keyguard designer here, along with a complete list of all changes made to the software.  The key changes are described below.

Changes you’ll find in version 67:

• This version of the designer introduces a fundamental change to grid layout design. At the same time, the names of a few Customizer options have changed to match this new approach to grid design. If you are upgrading to this version of the designer, it’s important for you to understand these changes, which are documented here.
• Instructions in the openings_and_additions.txt that create circular openings now use the “height” column to specify the diameter of the circular cut.  In previous releases, the “width” column was used.  By using the height column, these instructions can easily be modified to convert rectangular openings to circular openings.  You will need to make this modification to any designs where you add circular openings to your keyguard via instructions in the openings_and_additions.txt file.
• The option in the Bar Info section of the Customizer to “add rounded corners for strength” option with a “bar corner radius option” for simplicity and greater control over your design.

To be notified when a new version of the designer is released…

If you provide the information requested in the form below, we’ll email you each time a new version of the keyguard designer is posted. We promise not to abuse your trust by spamming you.